Philips 20LCD35 - Manual (Page 16)

Connect Peripheral Equipment
There is a wide range of video and audio
equipment that can be connected to your TV.
The following connection diagrams show you
how to connect them.
Preparation
Remove the backplate at the back of the TV as
shown on the illustration opposite.
Lay the LCD TV with the screen down on a
table as it will be easier to connect your
peripheral equipment. Please take your
precautions not to damage the screen.
With a eurocable
With a eurocable you will obtain a better
picture quality than with an aerial cable
only.
&
Connect the aerial cables 1, 2 and the
eurocable 3 as shown opposite.
é
Press the π key on the VCR.
The TV will switch to
AV1 mode
automatically.
If you want to keep on watching in TV
mode, press the cursor up/down,
+ P - or
press the digit keys
With an aerial cable only
&
Connect the aerial cables 1 and 2 as
shown opposite.
é
Search for and store the test signal
of the VCR.
• Unplug the aerial cable 1 from the aerial
socket x of your VCR.
• Switch on your TV and put the VCR on
the test signal. (See the handbook for your
VCR)
• Search for the test signal of your VCR in
the same way as you searched for and
stored TV channels. See Manual
programme tuning, p. 6.
• Store the test signal under a programme
number.
• Replace the aerial cable in the aerial
socket x of your VCR after you have
stored the test signal.
“
Select the programme number under
which the VCR is stored.
‘
Press the π key on the VCR.
Video recorder
VCR
CABLE
1
2
3
• •• • ••
S-VIDEO DC 15V _ +
VIDEO (MONO) L AUDIO R
AV2
L VIDEO L AUDIO R
MONITOR OUT ANT IN x75 Ω
w 1
............ ...........
VCR
CABLE
2
• •• • ••
S-VIDEO DC 15V _ +
VIDEO (MONO) L AUDIO R
AV2
L VIDEO L AUDIO R
MONITOR OUT ANT IN x75 Ω
w 1
............ ...........
1
15
Connect Peripheral Equipment
126 1013.1 gb 20-11-2001 14:31 Pagina 15