Philips 20LCD35 - Manual (Page 4)

Preparation
&
Place the TV on a solid surface.
Ensure that the TV is placed in a position
to allow free flow of air. Do not cover the
ventilation openings on the back cover.
To prevent any unsafe situations, no naked
flame sources, such as lighted candles,
should be placed on or in the vicinity.
Avoid heat, direct sunlight and exposure to
rain or water.The equipment shall not be
exposed to dripping or splashing.
é
Insert the aerial plug firmly into the
aerial socket
ANT IN x 75 Ω at the back
of the TV.
“
Remote control: Remove the cover of the
battery compartment. Insert the 2
batteries supplied (Type R6-1.5V).
1m
min.
ANT IN
x75 Ω
CABLE
.
‘
Power:This TV operates on a DC supply
provided by the AC-DC adaptor.The
voltage is as indicated on the label on the
back cover.
Only use the AC-DC adaptor supplied
with the TV and never apply an AC mains
to the TV directly.The AC-DC adaptor
operates on an AC mains supply, the
voltage is as indicated on the label of the
AC-DC adaptor.
Connect the DC plug of the AC-DC
adaptor to the DC 15V socket at the back
of the TV.
Connect the AC-DC adaptor and its mains
cord.
Insert the mains plug in the wall socket
having a mains voltage of 110V-240V.
(
Switch the TV on: Press the power key
at the front side of the TV to switch it on
or off.
If the TV is in standby mode, the standby
indicator in front of the TV illuminates brightly.
Press the standby key B again or the – P +
key or one of the digit keys on the remote
control to switch the TV on.
R6 / 1,5 V
3
Preparation
DC 15V
_ +
126 1013.1 gb 20-11-2001 14:30 Pagina 3