Philips 19S4LSB-27 - Manual (Page 11)

9
2. Setting up the monitor
Remove the base
Condition:
• For VESA standard mounting applications
Remove the 4 screws and then remove the base
from the monitor.
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface.
100mm
100mm
2.3 Remove base stand and base
(19S4L/
19S4LA )
Remove the base stand
Before you start disassembling the monitor base,
please follow the instructions below to avoid
damage or injury.
1. Place the monitor face down on a smooth
surface, taking care to avoid scratching or
damaging the screen.
2. Detach the base stand away from the base
column by:
(1) Use your fingers to loosen the screw
located at the bottom of the base.
(2) Gently move up-and-down to release the
latch that locks the base and pull the base
away from the base column.