Channel installation – Philips 50HFL3683S-F7 User Manual
Page 7
7
50HFL3683S
Channel installation
This section describes how to install the TV channels
automatically.
1
Connect the RF signal to the TV.
2
Plug the power cord into the power outlet.
Cable
ANT. IN
3
Turn the TV on.
•
Press
. POWER at the front of the TV or use the
. (POWER) on the remote control.
4
Press RC5 SETUP to put the remote control into setup
mode, then press the HOME/MENU button to display
the setup menu. (Hereafter, HOME/MENU will be
simply referred to as MENU)
5
Select Consumer TV setup - Setup - Autoprogram;
then select Cable. (unless the installation is using only
Antenna signals - in which case you would select
Antenna)
Note
•
The TV will not tune any channel that has not been fi rst
“installed”. This includes SPI direct tune commands!
LC10_PHILIPS_hospitality_EN_QG.indd 7
LC10_PHILIPS_hospitality_EN_QG.indd 7
2012/03/08 16:05:08
2012/03/08 16:05:08