Philips 50HFL3683S-F7 - Manual (Page 9)

9
50HFL3683S
Confi gure the Switch on settings
1
Press MENU and select Switch on settings.
2
Press Î or ï to select the desired mode, then press
OK.
Switch on
volume
Defi nes the pre-set volume level when TV is powered
on.
Maximum
volume
Defi nes the maximum limit of volume level except for
the external set top box.
Switch on
channel
Defi nes the power-on channel number or external
video input.
Power on
Determines the state of the TV when the AC power is
provided or restored.
On
Powers on TV after the AC power is restored.
(digital signage application)
Standby TV enters standby mode. (hospitality)
Last
status
Returns TV to the same state as before
power was interrupted. (general use)
Confi gure the Control settings
1
Press MENU and select Control settings.
2
Press Î or ï to select the desired mode, then press
OK.
TV RC
locked
Sets the TV operative or inoperative by guest remote
control.
TV keys
locked
Sets the TV operative or inoperative by local keyboard.
On
The control buttons on the TV are disabled
except for the Power button.
Off
The control buttons on the TV are enabled
and function normally.
All
All the control buttons on the TV are disabled
including the Power button.
OSD
display
Enable or disable to display the “On Screen Display”.
When you select Off, those settings below cannot be
displayed on TV.
- channel number / label / name
- “channel not valid” information
The rest of menus such as CC, Guest menu, Setup
Menu, Status Menu, Splash Screen, Sleep Timer, Sleep
warning Message, Freeze, Child lock Message and USB
Media Playback menu, etc. are still displayed.
EcoPower Sets the TV to reduce the power consumption.
SPI Port
Choose the SPI port connected to the external set
top box.
Off SPI Port is disabled.
3V3
SPI Port is enabled with the data and clock
line being pulled high to 3.3V voltage idle.
5V
SPI Port is enabled with the data and clock
line being pulled high to 5V voltage idle.
Standby
mode
Choose the standby mode when the TV goes into the
standby mode. When SPI Port is switched to 3V3 or
5V, Standby mode should be set to Fast to support all
the relevant SPI Port commands.
Green
While the TV is turned off in this mode, the
SPI functionality is limited. Once turned on,
complete SPI functionality is restored. Refer
to the full User Manual for more complete
information.
Fast
While the TV is turned off in this mode,
complete SPI functionality is maintained.
USB
playback
Enable or disable to support the feature of the USB
media playback. The USB cloning feature is always
enabled, regardless of this setting.
Note
• Supported USB Playback formats:
<JPEG>
Upper limit : 24Mpixel
<Motion JPEG>
Size : 320 x 240 (QVGA)
Frame rate : 30fps
Audio type : LPCM - Sampling frequency
(32 kHz, 44.1 kHz or 48 kHz)
- Quantization bit rate (16 bit)
LC10_PHILIPS_hospitality_EN_QG.indd 9 LC10_PHILIPS_hospitality_EN_QG.indd 9 2012/03/08 16:05:11 2012/03/08 16:05:11