Bosch HES7052U - Manual (Page 10)

English 8
4. Remove ground strap from center post, rotate so that wide end is at top and
attach wide end to range through hole below junction box. Attach green wire
on top of ground strap. Tighten Screw.
5. Attach red wire, round washer, star washer and nut IN THIS ORDER to left
post.
6. Attach white wire, round washer, star washer and nut IN THIS ORDER to cen-
ter post.
7. Attach black wire, round washer, star washer and nut IN THIS ORDER to right
post.
8. Tighten all connections securely and replace terminal block cover.
9. Properly secure strain relief (see previous section).
Note: DO NOT plug in range at this time.
5B) Three Wire Range Cord Connec-
tion
The Four Wire Connection (above) is preferred, but where local codes and ordi-
nances permit grounding through neutral and where conversion to four wire is
impractical, the unit may be connected to the power supply via a three wire con-
nection.
1. Disconnect electrical power at breaker box.
Figure 7: Four Wire Range cord Connection - Ground Strap and Wire
Figure 8: Four Wire Range Cord connection Continued
ground strap
green ground screw
ground wire
red
white
black