Philips 8060X-25 - Manual (Page 16)

ENGLISH
6 Replace the cutter back onto the Razor
Head Assembly making sure the blades are
pointing upwards.
C
7 Place the razor head comb back onto the
Razor Head Assembly.
Be sure to replace the comb back into the
original razor head before cleaning the next set.
C
8 Turn the razor head counterclockwise
until it locks into place.
9 Repeat the process for the other two sets
of cutters and combs.
C
10 Replace Razor Head Assembly back on
razor and push down (you will hear a
click).
The Razor Head Assembly will only fit correctly
in one position on razor. Make sure to align the
2 shaving lotion dispensing holes on the Razor
Head Assembly with the 2 shaving lotion tubes on
the razor.
Trimmer: After Each Use
1 Press the on/off button to turn razor ON.
2 Rinse the trimmer under hot tap water for
at least 30 seconds.
3 Turn razor OFF and shake off excess water.
30 ENGLISH
4 Lubricate trimmer teeth twice a year with
one drop of mineral oil.
5 Remove the trimmer and put it back into
the trimmer storage compartment on the
refill & charge stand.
6 Replace Razor Head Assembly back on the
razor until it clicks into position.
Pump Unit:
◗ It is recommended that you clean the refill &
charge stand pump unit each time you replace
the shaving conditioner bottle to remove any
residual shaving conditioner lotion. This
helps to prevent blockage of the pump unit.
1 Unplug refill & charge stand. Remove the
shaving conditioner bottle and razor from
stand.
C
2 Remove the panel on the back of the refill
& charge stand.
C
3 Gently pull the pump unit out from the
stand.
31
6
6