Philips 8060X-25 - Manual (Page 17)

ENGLISH
C
4 Thoroughly rinse the pump unit under hot
tap water for at least 30 seconds.
Make sure all residual shaving conditioner lotion is
removed.
5 Carefully place the pump unit back into
the refill & charge stand and reattach the
back panel.
6 Put the shaving conditioner bottle and
razor back into the refill & charge stand
(see ‘Preparing Refill & Charge Stand For
Use’).
Replacing Cartridges and Shaving
Conditioner Refill Bottle
◗ For hygienic reasons, it is recommended to
replace the shaving conditioner cartridge
each time you start a new shaving conditioner
bottle.
◗ A new empty cartridge is supplied with each
new NIVEA FOR MEN Shaving Conditioner
bottle (Model HS800).
Shaving Conditioner Cartridge
C
1 Remove the shaving conditioner cartridge
from the back of razor.
32 ENGLISH
C
2 Insert the hinge at the top of the new
shaving conditioner cartridge into the slot
in the rim of the razor back (1). Then
press the bottom part of the cartridge
with your thumb (2) to attach the
cartridge to the razor. You will hear a
‘click’.
3 The shaving conditioner cartridge is
now ready to be filled (see ‘Charging and
Refilling the Razor’).
NIVEA fOR MEN Shaving
Conditioner Bottle
◗ Only use NIVEA FOR MEN Shaving
Conditioner (Model HS800) with the refill
& charge stand. Any other lotion may cause
damage to your razor.
C
1 Remove the tab of the NIVEA FOR MEN
shaving conditioner bottle.
C
2 Turn the cap on the shaving conditioner
bottle clockwise.
The cap moves down and the shaving conditioner
nozzle appears.
3 Turn the cap of the refill & charge stand
counterclockwise to remove cap.
C
4 Place the shaving conditioner bottle in the
docking hole of the refill & charge stand
with the nozzle pointing down.
33