Philips 40PFL4907-F7 - Manual (Page 40)

English
40
Network
Set up network connection settings in order to use Net TV or network
upgrade function.
• The meanings of abbreviations are defined as below.
AP : Wireless LAN Access Point
WPS : Wi-Fi protected Setup
SSID : Wireless network name
• The key entry screen will appear when you select SSID,
WEP / WPA / WAP2 or Proxy address.
1 2 3 4 5 6 7 8 9 0
a b c d e f g h i j
k l m n o p q r s t
u v w x y z . - _
―
Clear All clear a/A/@ Cancel OK
• Enter the key of the selected wireless network using ▲▼◄►,
then press OK.
Clear : Clear the entered number or word.
All clear : Clear all the entered numbers or words.
a/A/@ : Switch between abc, ABC and @ ! ?
Cancel : Shows the cancellation display.
OK : Set the entered number or word.
1
Use ▲▼ to select Network, then press OK.
Picture Language
Sound Channels
Features Preferences
Installation Network
Software Reset AV settings
Network settings assistant
Before you proceed to Connection test or other settings in Network
section, set this selection to suit your preference.
2
Use ▲▼ to select Network settings assistant, then press OK.
Language Network settings assistant
Channels Manual network settings
Preferences Connection test
Network Setting status
Reset AV settings Reset network settings
3
Press OK to select Start now.
Wirelesssetting
Select to use a wireless LAN to connect to the Internet by wireless
connection.
4
Use ▲▼ to select Wireless, then press OK.
This TV can be connected to your home
network.
Select your connection type.
Wireless
Wired
Cancel
5
Use ▲▼ to select the desired setting, then press OK.
Easy connect
Select this setting if your router has a WPS
button. Start scanning for wireless networks on
the TV after pressing the WPS button on your
router. If connection test fails, try Easy connect
again.* 1
If it fails then refer to the router’s manual for
more details.
Scan
Search for wireless networks automatically
and select the SSID from the list.
Wireless network setting ➠ p. 41
Manual entry
Set up the connection to the AP (e.g. wireless
router) manually by entering the SSID.
*1 WPS (Easy Connect) cannot be used when the security protocol is set to
WEP. Change the Access Point’s security mode from WEP to WPA or WPA2
(recommended).
Wiredsetting
Select to use an Ethernet cable to connect to the Internet by wired
connection. Please purchase shielded Ethernet cables at your local store
and use them when you connect to network equipment.
4
Use ▲▼ to select Wired, then press OK.
• Connection test will start automatically.
➠
p. 42
Manual network settings
2
Use ▲▼ to select Manual network settings, then press OK.
Network settings assistant Network selection Wireless
Manual network settings Wireless network setting Auto
Connection test IP configuration IP setting mode
Setting status Proxy configuration Proxy setting
Reset network settings
Networkselection
3
Use ▲▼ to select Network selection, then press OK.
4
Use ▲▼ to select the desired setting, then press OK.
Wired
If you connect to an Ethernet cable, select Wired
to connect to the Internet.
Wireless
If you have a router with WPS function, select
Wireless to connect to the Internet.
Continued on next page.