LG V-3947TV - Manual (Page 5)

Your appliance is equipped with either a paper
dust bag or a fabric dust bag (24). (depending
on model)
· Take hold of the dust bag by the handle and
pull. Remove the bag and throw it away.
· To refit a new bag push the cardboard sup-
port of a new bag into the bag mount (25)
until it will go no further.
If your appliance is fitted with a fabric dust
bag follow the same instructions as above.
Empty it and replace it (26). Do not wash it.
Note : as the appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not fitted
correctly.
Cleaning the motor filter
The motor filter is situated inside the ap-pliance
between the dust bag and the motor. Each time
that you change the air outlet filter we advise
you to remove the motor filter (27) and to clean
it by tapping to remove the dirt and then
replacing it in the vacuum cleaner.
Changing the air outlet filters
Depending on the model you have chosen your
appliance is equipped with different types of
filters : foam filter or electrostatic filter or anti-
odour charcoal filter (28).
· To change these filters remove the cover of
the filter compartment (29) situated at the
rear of the appliance, by lifting the little catch.
· The foam filter, should be cleaned regular-ly
by tapping it to remove the dirt.
· The electrostatic filter or anti-odour
charcoal filter should be changed regular-ly
(approximately every 6 bag changes)
Check that the appliance is correctly plugged in
and that the electrical socket is working
· Stop the appliance and unplug it.
· Check that the tubes, flexible hose and
cleaning tool are not blocked.
· Check that the dust bag is not full. RepIace if
necessary.
· Check that the air outlet filter is not blocked.
Replace if necessary.
What to do if your appliance
does not work
What to do when the suction
performance reduces?
· If your appliance is equipped with an
automatic cleaning head (11) without
pedal, it automatically adapts to the type
of floor to be cleaned.
· Upholstery Nozzle(12)
For vacuuming upholstery, mattresses, etc.
The thread collectors help to pick up the
threads and fluff.
· Dusting brush(13)
For vacuuming picture frames, furniture
outlines, books and other uneven objects.
· Crevice Tool(14)
For vacuuming in those normally inaccess-
ible places i.e. reaching cobwebs, or down
the side of a sofa!
How to plug in and use
Pull out the mains lead to the desired length
and plug into the socket.
Press button (15) to start the vacuum cleaner.
To stop it press the button (15) again.
Adjusting the power level
(depending on model)
· Suction capacity increases steplessly up to
MAX.(17)
· The flexible hose handle (18) has a manual
air flow regulator (19) which allows you to
briefly reduce the suction level.
Park-System (20)
For short breaks during vacuuming, for ex-
ample to move a small piece of furniture or a
rug, use the Park-system to support the flex-
ible hose and cleaning head.
· Slide the hook attached to the large cleaning
tool into the slot on the rear of the appliance.
Carrying and storage (21)
When you have switched off and unplugged
the appliance, press on the button (16) to
automatically rewind the cord.
You can move or store your appliance in a
vertical position by sliding the hook on the large
cleaning head into the clip on the underside of
the appliance.
Changing the dust bag
The dust bag needs changing when the cleaner
is set to maximum power and the cleaner head
is off the floor but the Òbag fullÓ indicator win-
dow (22) is completely coloured red.
Even if the dust bag does not appear to be full
at this stage, it should be changed.
It could be that a great deal of very fine dust
has clogged up the pores of the dust bag.
· Turn off the appliance and unplug it.
· Open the cover by pressing the hook(23) and
lifting it up until it snaps into place.
_ 5 _