Philips AT920-41 - Manual (Page 10)

ENGLISH
Cleaning
w
Always clean your razor after each use.
w Always switch razor OFF, unplug and remove
power cord before cleaning.
w Never clean, remove or replace head
assembly while motor is on.
w Do not apply pressure to combs. Do not
touch razor heads with hard objects as this
may dent or damage precision-made slotted
combs.
w Do not use razor if combs are damaged or
broken. Facial injury may occur.
w Do not use compressed air, abrasives,
scourers or aggressive liquids such as gasoline
or acetone to clean the razor.
Cleaning the Shaving Unit
The razor heads may be quickly cleaned after
each use by rinsing with hot water: Water from
the tap should be on a hot setting, BUT BE
CAREFUL TO TEST WATER FIRST SO AS NOT
TO BURN OR SCALD HANDS.
w Regular cleaning guarantees better shaving
results.
w Do not immerse razor in water.
w While rinsing razor heads, water may drip
out of the base of razor. This is a normal
occurrence.
18
ENGLISH
1 Always turn razor OFF, unplug from outlet
and remove power cord from razor.
C
2 Press the Razor Head Release Button to
open the Razor Head Assembly.
C
3 Clean inside razor heads and hair chamber
by running under hot water.
C
4 Clean outside of Razor Head Assembly by
running under hot water.
5 Close the Razor Head Assembly and shake
off excess water.
Be careful not to hit the shaving unit against
anything while shaking off excess water.
6 Open Razor Head Assembly again and
leave open to air dry.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue. This could damage the
shaving heads.
w If you used foam or gel to shave, make sure
to rinse off all of it off to prevent residue
build-up from clogging razor heads.
19