Philips wireless microphone & Bluetooth® speaker AEA7000 for iPad - Manual (Page 10)

8 EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Connect power
Caution
• Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back of the unit.
• Risk of electric shock! When you unplug the AC power
cord, always pull the plug from the socket. Never pull
the cord.
• Before you connect the AC power cord, make sure that
you have completed all the other connections.
• Connect the AC power cord to
• the AC MAINS~ socket on the back
of the Bluetooth ® speaker.
• the wall power socket.
Switch on the Bluetooth ®
speaker
• Press on the top of the Bluetooth ®
speaker.
» The power indicator lights up white.
» The Bluetooth indicator flashes blue
slowly.
• To switch the unit to standby mode, press
on the top panel.
• To switch the unit on from standby mode,
press again.
Tip
• If the speaker stays idle for more than 15 minutes, it
switches to standby mode automatically.
Install/replace microphone
batteries
Caution
• Risk of explosion! Keep batteries away from heat,
sunshine, or fire. Never discard batteries in fire.
•
Danger of explosion if batteries are incorrectly
replaced. Replace only with the same or equivalent
type.
•
Batteries contain chemical substances, so they should
be disposed of properly.
1
Open the battery compartment and take
out the battery cartridge.
2
Insert 3 x AAA batteries (supplied) into
the cartridge with correct polarity (+/-) as
indicated.