Philips FWD798-37 - Manual (Page 38)

38
English
Tuner Operations
IMPORTANT!
–Make sure FM and AM antennas are
connected.
Tuning to radio stations
1
Press TUNER to select “ FM XX” or “MW XX”
(AM X).
2
Press and hold 1 / ¡ on the system or on
the remote control until the frequency indication
starts to change, then release.
➜ The next radio station will be tuned
automatically.
3
To tune a weak station, press
1 / ¡ on the
system or on the remote control to search until
a radio station with sufficient signal strength is
found.
Presetting radio stations
You can store up to 40 preset radio stations in
the memory, starting from FM and followed by
AM bands.
Automatic preset programming
You can start automatic presetting from a
selected preset number.
1
Press TUNER (BAND) to select TUNER mode.
➜ The current radio frequency will appear on
the display.
To begin automatic preset from a desired
preset number
●
Press O / P or numeric keys (0-9) to
select the desired preset number.
2
Press and hold PROGRAM for 3 seconds,
“
AUTO SEARCHING” appears on the display.
➜ PROG will start to flash.
➜ The system will start to search all radio
stations on the FM band, then AM band.
➜ All radio stations with strong signal strength
will be stored automatically.
➜
The system will stop searching when all
available radio stations are stored or when the
memory of 40 preset radio stations is full.
➜
The first preset radio station will then be
played when completed.
To stop storing the automatic preset
●
Press
7 to stop storing the automatic preset.
Note:
– If no preset number is selected, automatic
preset will begin from “
01” and all your former
presets will be overridden.
p026-051-FWD798_37_EngB 2006.5.22, 3:21 PM 38