Hale SMR - Manual (Page 13)

Section 5
VOLUTE BODY
It is extremely unlikely in normal servicing that the volute body will require to be
removed, but in the event of removal the front cover plate should be removed as in
Section 3. The volute is mounted on to the pump body by means of twelve studs,
nuts and washers. The seal at both front and rear faces of the volute is by O ring
seals, which should be replaced if the joint face is disturbed. This volute may be
mounted on either standard rotation pumps or reverse rotation pumps, and must be
fitted the correct way round (see the cast on arrow near to the manifold connecting
face, normally on the right hand side). The 12-mounting studs should always face
the rear of the pump.
©Godiva, Warwick
September 2000
wsmaint-Issue2 25-9-02 13