Hale SMD - Manual (Page 5)

Illustrated Parts Breakdown
Stainless Max Series Pumps 9-5
GENERAL
This section contains drawings and the parts breakdown for the serviceable assemblies, compo-
nents and most commonly used options for the Stainless Max Pump.
ABBREVIATIONS
The following abbreviations may be used in this IPB:
A/R .......... As required
Cm ........... Centimeters
Ext. .......... Exrternal
Fwd ......... Forward
Ga ........... Gauge
Grd, Gr .... Grade – when hardware lists a grade
rating, it is imperative to maintain that
rating when replacing parts.
HS ........... Hardened Steel
Hex .......... Hexagonal
Id, ID ........ Inner diameter
IPB .......... Illustrated Parts Breakwown
JIC ........... Joint Industry Conference – an
industry standard used to describe a
fitting.
Lh, LH...... Left Hand
MM .......... Millimeters
Mtg .......... Mouting
n/s ........... Not Shown – parts that are not
shwon but are servicable.
No............ Number
NPT ......... National Pipe thread
NPTF ....... National Pipe Thread, Fine
OD ........... Outer diameter
p/n ........... Part number
Ref........... Reference
Rev .......... Reverse
Rh, RH .... Right hand
Str............ Straight – usually ti describe a
hydraulic or pneumatic fitting (vs.