Fluid Management NSC50 Harbil - Manual (Page 11)

NSC50 Operating & Instruction Manual 11
ASSEMBLY & INSTALLATION
FILLING CANISTERS
After all of the canisters have been installed on the turntable, they can be
filled. Each canister has a maximum capacity of 2-1/2 quarts. It is
recommended that each canister be filled with two (2) quarts of colorant.
The maximum capacity of the pump is two (2) ounces.
The following steps represent the process by which the canisters should be
filled:
1. Locate the first canister and determine which colorant is to be placed
into that canister.
2. Place the appropriate decal on the canister.
3. Shake of stir the colorant following manufacturers recommendations.
4. Slowly, pour the colorant into the canister to the level of approximately
two (2) quarts.
5. Place the top on the canister.
6. Repeat these steps for each of the remaining canisters.
7. After all of the canisters have been filled, agitate by turning on the
agitation motor. This will release any air trapped in the colorant.
PRIMING OF PUMPS
Once the canisters have been both filled and agitated, the pumps attached to
each of the canisters must be properly primed. Follow these steps to prime
the pumps.
1. Locate the first canister.
2. Slowly pull the pump handle all of the way to the top of its stroke and
wait in this position for a count of approximately three (3) seconds.
3. Slowly press the pump handle all of the way down to the bottom of its
stroke.
4. Repeat these steps five (5) times.
5. Repeat steps 1 through 4 for each of the remaining canisters.