Gradall 534D-10 Service Manual - Manual (Page 19)

Form No. 20219 z z z z z 534D-9/534D-10 Owner/Operator Manual
Accelerator Pedal: Depress pedal to increase speed and release pedal to
decrease speed.
Alternator Indicator Light: Glows (red) to indicate alternator is not charging.
Attachment Tilt Lever: This lever controls tilt of the fork carriage. Speed is
proportional to lever actuation and engine RPM. Push lever forward to tilt down;
pull lever back to tilt up.
Attachment Tilt Switch (optional): Depress front of switch to tilt down; depress
rear of switch to tilt up.
Auxiliary Control Lever (optional): This lever is used to control optional
hydraulic attachments. Follow decal instructions for lever/handler movements.
Auxiliary Light Switch (optional): This switch turns auxiliary lights on and
off.
Boom Control Joystick: This joystick controls boom elevation and extension.
Pull joystick back to raise boom; push joystick forward to lower boom. Move
joystick to right to extend boom; move to left to retract boom. Speed of boom
movement is proportional to joystick actuation and engine RPM.
Check Engine Light (Deere Engines Only): Glows (red) for 30 seconds before
engine shuts down when a “Shutdown” fault is detected.
Engine Coolant Temperature Gauge: This gauge displays engine coolant
temperature.
Engine Oil Pressure Gauge: This gauge displays engine oil pressure.
Forward/Reverse Lever: This lever engages forward or reverse travel. Lift &
push lever fully forward for forward travel; Lift & pull lever fully backward for
reverse travel. Move lever to centered position for “Neutral”.
Fuel Gauge: This gauge displays level of fuel in fuel tank.
Heater Fan Switch (optional): This switch turns heater fan on and off.
Horn Button: Depress button to sound horn.
Hourmeter: This meter indicates total time of engine operation in hours and
tenths of hours.
Ignition Switch: This switch is actuated by a key. In “ACC” or “RUN” position,
voltage is available for all electrical functions. Full clockwise rotation to “START”
engages starter motor. Counter-clockwise rotation to “OFF” stops engine and
removes voltage from all electrical functions.
Level Indicator: This bubble level indicator enables the operator to determine
the left to right level condition of the handler.
Lights Switch (optional): This switch controls optional lighting which may
be provided with the handler.
Machine Level Lever: This lever controls the relationship of the handler frame
to the front axle. Push the lever forward to tilt frame to left, pull lever back to
tilt frame to right.
Parking Brake Switch: This switch controls the application and release of the
parking brake.
3.1
A brief description of controls and
instruments is provided here as a
convenience for the operator.
These descriptions DO NOT provide
complete operation instructions.
Read & understand this Manual,
and the GRADALL Material Handler
Safety Manual.
WARNING !