ARB RD135 - Manual (Page 25)

4 Installing the Air System
23
4.1 Mounting the Solenoid
4.1.1
Connection to an ARB Air Compressor (Fig.16.)
Remove one of the 1/8” BSP plugs from its port in the compressor
tank.
Apply Teflon paste to the nipple (1/8” X 1/8” BSP) and insert it into
the port and tighten.
Apply Teflon paste to the free end of the nipple.
Assemble the inlet port side of the solenoid (stamped with a ‘1’)
onto the nipple and hand tighten it. The solenoid should be rotated
into a position that does not obstruct any other ports on the
compressor tank.
NOTE : The solenoid exhausts compressed air through the
center of the black retaining cap when the Air Locker
is disengaged. Make sure this orifice cannot be
obstructed.
Apply Teflon paste to the threads of the 5mm push-in fitting and
assemble it into the solenoid outlet port (stamped “2”) and tighten.
Figure 16.
ARB
Air Compressor