ARB 3423020 - Manual (Page 6)

30 11 04 Page 6 of 8 3782653
19. Fit control box to control box bracket and
tighten firmly.
20. Pull wires through viewer cutout under control
box and wire up as per Warn instruction manual.
21. Tie back cables clear of all moving parts with
cable tie supplied.
22. Place ground earth lead under bolt of winch
tension bar.
FOR 2002 MODELS ONWARD go to step 23.
FOR PREVIOUS MODELS go to step 24. (The parts listed in step 23 will not be required)
23. Push the 3 M8 “U” nuts onto the sump guard
support and bolt the chassis extension and support
to the front of the chassis using 2 M12 x 35mm
fine pitch bolts, flat washers, spring washers and
rectangular packer.
24. Fit impact absorbers to both sides of the
vehicle.
25. On LHSide of vehicle, refit tow hook using
original 12mm bolts.
26. Prior 2002 models, fit 12mm x 30mm fine
pitch bolt to the front of the chassis.
2002 models on, fit 12mm x 25mm course pitch
bolts to the front of the chassis extension.
27. From underneath of bracket, drill right through,
using ½” drill bit and fit 4 ½” bolt upward with
washers and nut.
28.On RHSide of vehicle under impact absorber,
relace tie downs and bolt up using 12mm x 40mm
bolts etc.
29. When all bolts are fitted, finger tighten only.