ARB 3423030 - Manual (Page 5)

01-09-06 Page 5 of 15 3783174
8. Secure from underneath using large
12mm gold coloured flat washer,12mm
spring washer and 12mm nut to both
sides of vehicle.
See Photo:
9. Secure lower fixing point by passing
through lower bracket in a upward
motion, using M12 bolt, 12mm flat
washer and secure from the top using
large gold coloured 12mm flat
washer,12mm spring washer and
12mm nut ( fine thread ) to each side of
vehicle. When all bolts are fitted,
tighten securely.
10 Lastly fit tension brackets to each side
of vehicle. The two front fixing bolts are
M10 x 30mm,flat washers, spring washers
and M10 nuts. The rear bolt is 4” x ½’
which is passed through the chassis from
outside of vehicle and fitted with a large
gold 12mm washer and a ½’Nyloc nut on
the inside of vehicle. When all bolts are
fitted, tighten front 10mm bolts securely
and tighten rear ½” bolt to a torque setting
of 30ft lb ( NO MORE )
PHOTO VIEWED FROM UNDER
LHS OF VEHICLE
ARROW INDICATES THE ½” BOLT
PHOTO IS OF RHS OF VEHICLE