ARB 3432080 User Manual

Warning

Advertising
background image

20-7-00

Page 1 of 3

3782852




If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.

Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807

WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190

DELUX WINCH BULL BAR TO SUIT

LAND ROVER DISCOVERY

PART No 3432030-080

WARNING

THIS BULL BAR MUST NOT BE FITTED TO AIRBAG EQUIPPED VEHICLES.

FITMENT TO AIRBAG EQUIPPED VEHICLES MAY INTERFERE WITH THE

PROPER OPERATION OF THE AIRBAGS AND MAY RESULT IN SERIOUS INJURY.

TAKE NOTE OF THE FOLLOWING:

THIS PRODUCT MUST BE INSTALLED EXACTLY AS PER THESE INSTRUCTIONS

USING ONLY THE HARDWARE SUPPLIED.

IN THE EVENT OF DAMAGE TO ANY BULL BAR COMPONENT, CONTACT YOUR

NEAREST AUTHORISED ARB STOCKIST. REPAIRS OR MODIFICATIONS TO THE

IMPACT ABSORPTION SYSTEM MUST NOT BE ATTEMPED.

DO NOT USE THIS PRODUCT FOR ANY VEHICLE MAKE OR MODEL, OTHER THAN

THOSE SPECIFIED BY ARB.

DO NOT REMOVE LABELS FROM THIS BULL BAR.

THIS PRODUCT OR IT’S FIXING MUST NOT BE MODIFIED IN ANY WAY.

TOOLS REQUIRED-

Basic toll kit
½” capacity drill & ½” & 6mm drill bits

REFER TO WINCH FITTMENT DETAILS BEFORE PROCEDING

PROCEDURE-

1. Remove bumper from bar from vehicle.

2. The lower steering arm protector must be loosened off at its side pivot points.

3. Remove plastic skirt from bumper if skirt is going to be refitted to bull bar.

4. Fit indicators to bar and tighten.

5. Lay bull bar down so back of bar is facing upwards.

6. Fit plastic skirt into back of bar and bolt to skirt mounting brackets on bar using 20mm x

8mm bolts etc, finger tighten only.


7. Hold plastic skirt surround against bull bar surround firmly, drill 6mm hole through top of

bar using hole in bar as template.


8. Place 6mm domed head bolts through bar and 80mm diameter washer under plastic skirt

from inside of bar and fit 6mm flange nuts, tighten firmly.

Advertising