ARB 3432050 - Manual (Page 3)

25-9-98 Page 3 of 6 3782513
TOOLS REQUIRED
Basic tool kit, level, tape measure, drill and 1/2” drill bit.
FITTING PROCEDURE
1. Disconnect the headlight washers at the T piece by cutting the tube, take care as the T piece is fragile.
NOTE: First temporarily block the tube to prevent loss of washer fluid.
2. Remove the bumper bar.
3. Remove the headlight washers and tubing from the bumper bar and fit to the bull bar. Make sure the tubing is fed
through the holes in the bull bar upright.
4. Fit the turn signal indicators supplied into the bull bar. NOTE: Refer to the instructions supplied with the turn
signal indicator kit.
5. WINCH BARS: FITTING THE 8 OR 9,000lb WINCH
A. Fit the control box to the control box bracket using the two 1/4” nuts, washers and spring washers. Bolt the
control box bracket to the bull bar using the M8 x 20mm bolts, flat washers and flange nuts supplied.
DIAGRAM 1