ARB 3450080 User Manual
Page 4
20-5-98
Page 4 of 4
3782549
DIAGRAM 4
21. Align the bull bar and tighten the two 3/8” bolts.
22.
Using the bull bar as a template. Drill out the lower forward holes in the chassis to ½”. (Refer to
diagram 4.)
23.
Insert the 2 captive nut plates into the inside of the chassis rail with the tab towards the front. Fit the
four 1/2” x 1 ½” bolts, spring washers and flat washers and tighten all bolts.
NOTE: Due to variations in the vehicle chassis rails it may be necessary to place a packer between the
chassis and the bull bar. Packers are supplied for this purpose.
24. Fit the vacuum canister to the inside of the LH wing with the original screws and connect the line.
25. Assemble the number plate bracket and number plate onto the bull bar using the M6 x 16mm bolts,
flat washers and flange nuts from the bolt kit.
26. Fit the indicators to the bull bar and connect the indicator looms to the existing indicator loom with
the Scotchloks supplied. Test to ensure the indicators function correctly.
27. Refit the splash pan.
28. Re-attach the inner guard to the bull bar using the four M6 bolts, flat washers and flange nuts.
NOTE: Read the winch manual carefully before operating the winch.