ARB 3444060 - Manual (Page 2)

6-5-99 Page 2 of 4 3782586
BULL BAR FITTING KIT No 6171299
USE PART No QTY DESCRIPTION
CHASSIS BRACKET TO 3751747R 1 CHASSIS BRACKET (RHS)
VEHICLE 3751747L 1 CHASSIS BRACKET (LHS)
6151096 4 M12 X 40mm BOLT
4581050 4 M12 SPRING WASHER
4581049 4 M12 FLAT WASHER
6151135 2 M12 NUT
4581057 2 CRESCENT MOON WASHER
4581008 2 OFFSET WASHERS
5846277 4 PACKER
PIN BULL BAR TO VEHICLE 6151087 2 M10 X 25mm BOLT
4581040 4 M10 FLAT WASHER
4581048 2 M10 SPRING WASHER
6151133 2 M10 NUT
BULL BAR TO CHASSIS 6151094 6 M12 X 30mm BOLT
BRACKETS 4581050 6 M12 SPRING WASHER
4581049 12 M12 FLAT WASHER
6151135 6 M12 NUT
6151087 2 M10 X 25mm BOLT
4581040 4 M10 FLAT WASHERS
4581048 2 M10 SPRING WASHERS
6151133 2 M10 NUT
CONTROL BOX BRACKET 3751581 1 CONTROL BOX BRACKET
6151200 2 M6 X 20mm DOMED HEAD BOLT
4581072 2 M6 X 20OD FLAT WASHER
6151128 2 M6 FLANGE NUT
NUMBER PLATE TO BAR 6151017 2 M6 X 16mm BOLT
6151128 2 M6 FLANGE NUT
4581035 4 M6 X 16OD FLAT WASHER
WINCH TO BAR 4581040 4 M10 FLAT WASHER
3500080 1 ARB INDICATOR KIT
180302 4 CABLE TIES
3500200 1 BUFFER KIT
TOOLS REQUIRED
Basic tool kit, drill, 10mm and 12mm drill bits.
FITTING THE 9,000lb WINCH
1. Place the bull bar on a suitable stand.
2. To place the winch clutch handle in a convenient location the winch gearbox must be rotated 4 hole spacings,
144 degrees, in an anti-clockwise direction when viewed from the gearbox end. Place the winch on its end and
remove all gearbox bolts. Gently raise the gearbox just enough to rotate it. Do not completely remove the
gearbox and avoid damaging the gasket. Refit all bolts and tighten. (Refer to diagram 1.)
NOTE: The winch handle is positioned near the bottom of the bull bar. The gearbox is situated on the left hand side
of the bull bar (as viewed from inside the vehicle). The cable spools from the bottom.