ARB 3448040 - Manual (Page 2)

29-11-00 Page 2 of 3 3782862
4. Fit 1 1/2” x 1/2” bolts to the inner bull bar chassis bracket with flat and spring
washers and nuts. Tighten all bolts and nuts.
5. Using 10mm x 1.25 hardware supplied and original bolts refit tow hook.
6. Making sure the bull bar is fitted correctly, locate the 10mm hole in the bull bar
chassis bracket and drill out chassis using this hole as a guide. Fit 10mm
hardware and repeat on the other side. Tighten bolts.
Note: Fit heavy duty offset washers pt/no 481008 to outer side of chassis bracket.
WINCH FITMENT –
1. To fit winch into bull bar the winch gearbox must first be rotated to ensure
control handle is in the correct location. Loosen & remove all cap headed
bolts – CAUTION: DO NOT remove gearbox. Lift the gearbox just high
enough to rotate handle to the new position as per drawing.
2. New mounting holes must be drilled in the roller fairlead as per the
attached drawings. Mark out new holes 30mm down from the original
holes and drill holes to 13mm or 1/2”.
3. Fit number plate bracket to bull bar using 6mm x 20mm bolts, washer,
spring washers & nuts supplied.
Fit the rubber grommet to the hole in the top pan of the bull bar.
4. Remove the roller fairlead side rollers by removing the circlip from each
pin. These pins will later be replaced with bolts.
5. New winch to control box leads have been supplied which are longer than
standard. Fit these new leads to the control box exactly as the original
leads were attached.
6. Mount winch into the rear of bull bar. Locate top holes first & finger tighten
3/8” x 1 1/2” bolts & 3/8” x 1” washers into winch. Place roller fairlead over
lower holes & fit bolts & washers. Ensure winch is correctly aligned &
tighten all bolts.
Using 6” bolts supplied, place a flat washer under the head of both bolts
and insert bolts through roller fairlead bracket & side rollers. Fit nyloc nuts
& tighten so that rollers turn freely.
7. Fit winch control box bracket to bull bar using 8mm x 20mm bolts,
washers, spring washers & nuts. Mount winch control box to bracket using
nuts supplied on control box.
8. Fit bull bar to vehicle following procedure overleaf
9. Wire up winch as per winch manual instructions.
10. Check operation of winch as per winch manual.