ARB 3936020 - Manual (Page 8)

13/6/08 Page 8 of 11 3786946
12.
Fitting with winch
Fitting without winch
If fitting with winch.
Peel off one side of the double sided tape and
adhere to the top rear side of the number
plate. Note: Clean the adhering surfaces
before applying tape with an alcohol solvent.
Peel off the other side of the tape and bolt to
the winch bumper with the M6 X 16mm bolts
and M6 flange nuts through the lower holes of
the number plate.
Press firmly to the top of the number plate so
the tape can properly adhere.
If not fitting with winch.
Bolt the number plate through the top holes
using M6 X 16mm bolts and M6 flange nuts.
If desired the double sided tape can be used
down the sides of the number plate.
13. If not fitting winch.
Wrap rubber extrusion around winch cover.
Place washers over the winch cover fixing
holes located on the top middle face of the
winch bumper.
Place the winch cover on top of the winch
bumper inline with the mount holes.
Bolt together using the M6 button head
stainless steel screws and M6 nuts.
14.
Remove the rubber air guide and discard.
IMPORTANT :- When fitting a winch, on some
models the top power steering cooler line (
steel ) will interfere with the winch and must be
bent down to provide clearance as shown .
Take care when bending the cooler line
tube that you don’t kink it.
Leave the power steering cooler in its original
position.