ARB 82QT-10800782 - Manual (Page 15)

6.5 Cable clips
Your ARB Fridge Freezer has clips on the rear panel of the unit to retain both the
12/24V DC and 100-240V AC cables. The cable clips are correctly sized for the power
cables supplied with your fridge freezer. The left hand cable clip shown in Figure 10a is
for the 100-240V AC cable. The right hand clip is for the 12/24V DC cable as shown in
Figure 10b.
Figure 10a Figure 10b
100-240 V
cable clip
12/24V
cable clip
To install the cable into the cable clips:
Plug the power cable into the correct power socket. Refer to section 6.4.
Starting at the end closest to the plug, press the cable into the cable clips using a
rotating action. The rotating action will help slide the cable under the clips.
NOTE - Care should be taken when installing and removing the cables to
prevent damaging the body o the fridge freezer or the power cables. f
l i t t WARNING - The cable c ips are s zed for he cables supplied wi h your fridge
freezer. ARB does not recommend using other cables in these cable clips.
6.6 Energy saving advice 6.6 Energy saving advice
To help you achieve the optimum performance from your fridge freezer, ARB makes the
following recommendations.
To help you achieve the optimum performance from your fridge freezer, ARB makes the
following recommendations.
Place the fridge freezer in a well ventilated area which is protected from direct
sunlight.
Place the fridge freezer in a well ventilated area which is protected from direct
sunlight.
Try to minimise the frequency with which the fridge freezer is opened.
Try to minimise the frequency with which the fridge freezer is opened.
Do not leave the lid open for longer than necessary.
Do not leave the lid open for longer than necessary.
Avoid setting the target temperature unnecessarily low.
Avoid setting the target temperature unnecessarily low.
Defrost the fridge once ice starts to form.
Defrost the fridge once ice starts to form.
14