Steele Products SP-PT211 - Manual (Page 12)

Circular Saw
12
2. Support the panel or board close to the cut. Be sure to set the blade adjustment so that you
can cut through the material without cutting into the table or workbench. Suggestion: use two
by fours (2”× 4”) to support the board or panel to be cutting. If the work piece is too large for
the workbench, use the floor with two by fours (2”× 4”) to support the wood.
Warning !
Preventive maintenance performed by unauthorized personnel may result in misplacing of internal
wires and components which could cause serious hazard.
CAUTION !
Always be sure that the tool is switched off and unplugged before attempting to perform inspection
or maintenance.
Regularly clean the tool’s air vents with compressed dry air. do not attempt to clean by inserting
pointed objects through openings.
CAUTION!
Certain cleaning agents and solvents may damage plastic parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia.
WARNING!
If any of the following events occur during normal operation, the power supply should be shut off at
once and tool thoroughly inspected by a qualified person and repaired if necessary:
> The rotating parts get stuck or speed drops abnormally low.
> The tool shakes abnormally accompanied by some unusual noise.
> The motor housing gets abnormal hot.
> Heavy sparks occur around the motor area.
Hex Wrench ---------------------------------1pc
Edge guide-----------------------------------1pc
Instruction Manual--------------------------1pc
MAINTENANCE
ACCESSORIES