Steele Products SP-PT211 - Manual (Page 9)

Owner’s Manual
9
9. Angle Locking knob
10. Spindle Lock
11. Brush Cap
12. Front Handle
13. Trigger Switch
14. Lock-off Button
15. Depth Locking Lever
Check for damage to the tool, parts and accessories which may have occurred during transportation.
Take some time to read this manual carefully and understand all the content prior to assembly and
operation.
CAUTION!
Always ensure that the tool is switched off and unplugged from the mains supply before assembly.
Changing the Blade
1. Place the saw on a side of a flat surface.
2. Rotate the saw blade by hand while depressing the Spindle Lock Button until the blade is locked,
Turn the blade clamp screw use the wrench provided in anti-clockwise direction.
3. Remove the blade clamp screw, outer flange, and washer.
4. Lift the lower guard by using the lower guard lever and remove the blade.
5. Clean the saw blade flanges, and then mount the new saw blade onto the spindle, which is
against the inner flange.
6. Make sure the saw teeth and arrow on the blade is to the same direction as the arrow on the
lower guard.
7. Reinstall the outer flange, washer and tighten the blade clamp screw.
8. Make sure the saw blade can run freely by turning the blade by hand.
ASSEMBLY
Fig. 2