AKiTiO Taurus Mini Super-S3 LCM - Manual (Page 12)

Taurus Mini Super-S3 LCD Display
[10]
3.4.2 RAID Mode Setup
In order to set the RAID mode, make sure the RAID switch is in the unlocked position.
• [RAID 1] Confirm RAID 1 mirroring mode.
• [RAID 0->1] Change the mode from RAID 0 striping to RAID 1 mirroring.
• [RAID 0] Confirm RAID 0 striping mode.
• [RAID 1->0] Change the mode from RAID 1 mirroring to RAID 0 striping.
Press the [OK] button to enter the setup menu and press the [Select] button to cycle through the
different options.
• To exit the menu without changing any of the settings, press the [Select] button until you see
the Exit screen and then press the [OK] button.
• To change the setting, press the [Select] button to choose your preferred mode, press the [OK]
button to select it, press the [OK] button again to confirm the change and once more to
acknowledge that all data will be erased by this change. The device will restart automatically
and after start up, one more confirmation is required to set the new RAID mode.
Note
Changing the RAID mode requires you to re-format the drives. Make sure to backup all
existing data first!