Bosch SHV 6800 - Manual (Page 14)

ENGLISH - 13
www.boschappliances.com
Rinse Agent
Rinse agent, or a rinse aid, is used to provide
optimum drying results and diminish water spot-
ting. Always use a rinse agent with the Bosch
dishwasher to insure proper drying results. It
rinses the dishware and also rinses the internal
parts of the dishwasher.
Rinse Agent Indicator Light
Some models are equipped with an additional rinse
aid indicator light on the control panel. When the
rinse agent dispenser is empty, the indicator light will
glow and the level indicator will show a silver back-
ground with black lines.
After filling the rinse agent dispenser, close the door
and wait a few minutes for the indicator light to reg-
ister.
Rinse Agent
Dispenser Regulator
The rinse agent reservoir of the Bosch dishwasher is
provided with a regulator calibrated from 1 to 6. (See
Figure 21.) This regulator controls the amount of
rinse agent dispensed. The dishwasher leaves the
factory preset to 4. However,
Note: Refill rinse agent when
the level indicator shows a silver
background with black lines.
Rinse agent is available in liq-
uid or solid form. Only use the
liquid type of rinse agent in
the Bosch dishwasher.
1. Open the dishwasher door fully.
2. Open the cover of the rinse agent dispenser by
pressing the star on the cover with your index
finger while pulling on the tab with your thumb.
3. Add rinse agent to the reservoir until the level
indicator turns dark, indicating that the reservoir
is full (capacity is approx. 3.5 oz.).
ADDING RINSE AGENT
• if you see streaks, you should turn the
regulator to a lower number.
• if you see water spots, you should turn
the regulator to a higher number.
To Fill the Rinse Agent Reservoir:
TO ADJUST RINSE
AGENT REGULATOR
SETTING:
1. OPEN THE COVER
OF THE RINSE AGENT
DISPENSER.
2.TURN THE SETTING
INDICATOR TO THE
DESIRED SETTING.
Figure 21
Figure 22
Figure 23
Rinse agent level indicator