BNC 1621M - Manual (Page 18)

To use the dosimeter in data transmission to PC mode:
• Read and follow the recommendations of the fi le Read_me.doc on
the CD supplied with IR adapter;
• Read the help fi le Help_ 1621.doc;
• Connect the adapter of IR communication channel to a PC COM port;
• Install the IrDA communication unit and switch on the IR connection;
• Install the program “System of Data Collection and Processing for the 1621/
1603/1604 Devices” from the CD, (run the program \DISK1\SETUP.EXE);
• Run the program 16XX.EXE;
• Read the help section of the program “System of Data Collection and
Processing for the 1621/ 1603/ 1604 Devices”;
• Orient the dosimeter and adapter of IR communication channel of the
PC by placing the dosimeter at a distance of 10-20 cm from the IR
channel adapter;
• Choose the mode of data transmission to PC using the MODE button
• Press and release the LIGHT/SET button for PC link startup through
IR channel;
• Perform readout of the dosimeter’s information following the program’s
instructions.
In data transmission to PC mode, the dosimeter provides the following functions:
1. Permission or prohibition of the following operating modes
(parameters) of the dosimeter:
• DER indication;
• Indication of DER coeffi cient of variation;
• Indication of DER averaging time;
• DE indication;
• Indication of DE accumulation time;
• Indication of time remaining for stay at the working place depending on
the current measured DER and DE values;
• Indication of the dosimeter s number;
• Audible alarm;
• Preset of the DE and DER threshold levels using the buttons;
• DE reset using the buttons.
17