Poison Spyder JK LED LICENSE PLATE & 3RD BRAKE LIGHT - Manual

©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
INSTALLATION INSTRUC
TIO
NS
41-06-040 • LED License Plate & 3rd Brake Light - PSC Connectors
Thank you for purchasing Poison Spyder’s JK
LED License Plate & 3rd Brake Light - PSC
Connectors. This installation assumes the use
of Poison Spyder’s JK LED Taillight Harness
- Passenger Side and 4” round LED taillights
sold separately by Poison Spyder Customs.
The following installation procedure is to be
performed in conjunction with the installation of
the LED Taillight Harness, instructions for which
are included with that product.
Installation is fairly simple with the right tools
and good mechanical abilities. If you are not
confident in your mechanical skills, please
seek the help of a professional to perform the
installation. Please read through these entire
instructions before proceeding with installation.
PARTS LIST
Please check your packages immediately upon
arrival to ensure that everything you ordered
is included, and to check for damage during
shipping. If anything is missing or damaged,
call Poison Spyder at (951) 849-5911 as soon
as possible.
(1) LED License Plate & 3rd Brake Light -
PSC Connectors
(1) JK Third Brake Light Jumper Wire
(1) 1/4” OD Air Brake Hose - 18” long
TOOLS NEEDED
• Picks (90-degree and straight)
• Small needle-nose pliers
• Electrical tape
• Zip-ties
INSTALLATION PROCEDURE
It is assumed that the LED Taillight Harness
installation is already in progress, the Jeep is
parked and secured, and the passenger side
taillight has already been removed as detailed
in the instructions that come with that harness.
1. Open the tailgate and remove the two
plastic covers on the inside surface of the
tailgate. For the small vertical cover, grip it
along the forward edge (facing the tailgate
hinge) and squeeze to release the tangs
while pulling the cover away.
FIGURE 3
2. Remove the long horizontal cover by
gripping the bottom edge, and squeeze to
release the tangs while pulling the bottom
edge of the cover away. With the lower
tangs released, slide the cover downward to
release the upper tabs and remove the cover.
JK LED LICENSE PLATE & 3RD BRAKE LIGHT