SkyTrak 6036 Tier II Operation Manual - Manual (Page 142)

136 Model 6036
General Maintenance
5. Pressurize the parking brake with the pressurizing unit. Close the
needle valve on the pressurizing unit.
6. Working through the level plug hole (1), carefully use a screwdriver
to spread the brake discs apart.
IMPORTANT! DO NOT damage the surfaces of the brake discs when
spreading the brake discs.
7. Using a feeler gauge, check the gap (1) between the brake discs
(2). If the gap is greater than .167" (4,25 mm), replace the brake
discs.
NOTE: If the brake discs are worn beyond .167" (4,25 mm), the brake disc
must be replaced on both sides of the axle at the same time.
8. Repeat steps 6 and 7 for the other side of the axle.
9. Continue with step 6 of “B. Axle Oil Change” on page 133.
MT2850
1