PureFlow AirDog DF-165 - Dodge Cummins 1998.5-2004 - Manual (Page 12)

12
PureFlow AirDog
AirDogII
®
Dodge 1998.5 - 2004
Section 5-A Fuel Lines
5A-6. You may either remove the factory supply line between the filter canister and the
injection pump OR you may leave the stock lines in place and just secure them out of the
way. Should you decide to remove your stock lines you will need to plug the ports on the
filter canister to prevent fuel spillage.
Figure 17
03+ Filter Canister 2000-02 Filter Canister
NOTE: Be sure to keep the ORIGINAL ENGINE RETURN LINE connected as it is from the
factory! In many cases the return runs thru the flange of the filter canister.
This section is for the 2003 – 2004 Dodge
Fuel Supply Line from the AirDog
®
to the CP3
The AirDog II fuel filter has a 2 micron media. When installing the AirDog II fuel system it
is recommended to bypass the factory filter canister.
5B-1. Remove the “banjo bolt” and the original factory fuel supply line at the fuel inlet port
of the CP-3 high pressure pump.
Figure 18
5B-2. From this point, installation of the pressure hose assembly is the same as described in
Section 5A-2 through 5A-6.