PureFlow AirDog FP-150 - Dodge Cummins 2005-2013 - Manual (Page 13)

13
PureFlow AirDog
AirDog
®
FP-100 & FP-150 Dodge 2005 - Present
Section 5-B cont’d
5B-3. Insert the female quick connect end (see figure 20) of the “pressure hose assembly”
into the male quick connect fitting previously installed in the port marked
“ENGINE”. You will hear a “click” when it connects.
Figure 20
5B-4. Connect the other end of the “pressure hose assembly” to the inlet fitting installed in
step 5B-2. It too will “click” when properly connected
5A-5 Any excess fuel hose can be addressed by routing the hose in a fashion to take up the
extra length, or a section of the hose can be removed. Push lock splices have been
included if you choose to remove the excess hose.
5A-6. It is advised to remove the factory supply lines between the tank and the filter
canister. Also remove the factory supply line between the filter canister and the
injection pump. Then plug the ports on the filter canister. This will prevent fuel
spillage.
Figure 21
NOTE: Be sure to keep the ORIGINAL ENGINE RETURN LINE connected as it is from
the factory! In many cases the return runs thru the flange of the filter canister.