PureFlow AirDog RP-150 - 6.0L Ford 2003-2007 - Manual (Page 10)

10
Raptor™ 100 & 150
2003 - 2007 Ford PowerStroke
Section 5-A Fuel Lines
Fuel Line from the Raptor to the High Pressure Pump.
5A-1 Remove the original factory fuel supply line at the electric OE lift pump, located on the
driver’s side inside frame rail by squeezing the tabs on the end of the connector
together. Push the quick connect fitting toward the OE lift pump while firmly
depressing the tabs. With the tabs depressed, pull the fitting assembly from the inlet
tube. Use care to hold the quick connect fitting squarely onto the inlet tube. It may be
difficult to disconnect the fitting if it becomes cocked during removal.
High Pressure Fuel Pump
With 3/8” Quick Connect Fitting
Figure 5
5A-2. Attach, by pushing, the female SAE J2044 quick connect end (Figure 6) of the “Pressure
Hose Assembly” onto the factory male quick connect that was disconnected in 5A-1
(Figure 15). You will hear a “click” when properly connected.
Figure 6
5A-3. Insert the female quick connect end (see figure 7) of the
“Pressure Hose Assembly” into the male quick connect fitting
previously installed in the port marked “OUT”. You will hear a
“click” when it connects.
Figure 7
5A-4. Any excess fuel hose can be addressed by routing the hose in a fashion to take up the
extra length, or a section of the hose can be removed. Push lock splices have been
included if you choose to remove the excess hose.