Figure 1, Figure 4, Figure 3 – Hyline Offroad TJ TUBE STEP ROCKER PANEL User Manual
Page 2: Figure 2, Figure 5
IMPORTANT NOTE: ANY SAHARA OR ANNIVERSARY MODEL WITH UPGRADED TRIM OPTION MUST REMOVE
FACTORY STEPS AND PLASTIC ROCKER PANEL COVER BEFORE INSTALLING HYLINE’S ROCKER PANELS
Tube Step Rocker Panel Installation
Step 1 – Remove plastic fender flare extensions by using 8mm wrench
to remove 3 screws (See Figure 1). You WILL have to drill
out the three threaded inserts. Do this by SLOWLY & LIGHTLY
drilling with a drill bit about the same size as the diameter of the
threaded insert. Drill until the head of the insert is removed, then
using a punch you can pop the inserts out of the sheet metal.
Step 2 – Install Paint Guard Foam onto Rocker Panel by peeling back paper to expose adhesive. Cut any excess
foam material off and cutout holes.
Step 3 – Thoroughly clean the area of the Jeep body
that the Rocker will be mounted to both
under the door and underneath the body.
Step 4 – Remove the body mount bolts from the
following places using 16mm socket:
1 – Front Center (Fig. 2)
3 – Passenger Side (Fig. 3)
1 – Next to the Rear Shock Mount (Fig. 4)
1 – Below the Rear Corner Panel (Fig. 5)
T:\Hyline Offroad, LLC\Installation Instructions\TJ-30TSR\TJ-30TSR Installation Instructions.doc
Page 2 of 4
REV 0 12/2/08
PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION
NOTE: Before staring installation, Park you Jeep on flat, level
area and set the parking brake and emergency brake.
INSTALL ONE ROCKER PANEL AT A TIME!
Passenger Side Shown. Complete
one side installation