Hyline Offroad TJ TUBE STEP ROCKER PANEL - Manual (Page 3)

Step 5 – Once the body mount bolts are removed you can use the
floor jack and extension board to raise the passenger side first.
(See Figure 6 for best jacking location)
Raise the body enough so that you’re able to remove the body mounts.
Step 6 – Remove the two body mount bushings that are shown in Figure 7.
Remove the metal cap washer from bushing before trimming.
You will need to cut about 1/8” off of the rubber body mount bushings,
to allow for the material thickness of the Tube Step Rocker.
(See Figure 8: Trimmed rubber bushing)
Step 7 – Place the two metal cap washers from the bushings into the two holes
on the Tube Step Rocker as shown in (Figure 9). Also, place the trimmed
rubber bushings back into the body mount brackets on the Jeep.
Then slide the Tube Step Rocker into place onto the Jeep side while
positioning the metal cap washers into the rubber bushings.
Gently lower the body back down.
Step 8 – Position/Center Tube Step Rocker on the Jeep to prepare it for drilling.
Make sure it’s exactly where you want it before continuing.
Step 9 – Re-install the 3 Body Mount Bolts and Hand Tighten Only
T:\Hyline Offroad, LLC\Installation Instructions\TJ-30TSR\TJ-30TSR Installation Instructions.doc
Page 3 of 4
REV 0 12/2/08
You only have to trim down the two body mount
bushings located directly beneath the
passenger and driver side doors. The
other bushing that is closer to the front
DOES NOT have to be trimmed and will
remain in place.