GFB EX50 50mm External Wastegate (part 7001) - Manual (Page 4)

The second configuration is a simple adaptation of the
above, with a boost controller (such as the GFB Atomic)
fitted into the pressure hose as shown to allow the boost
to be easily increased above the base level.
In the case of the Atomic boost controller, the arrow on
the body must point in the direction shown, or the
controller will have little effect.
If using a different brand controller, you should consult
the instructions for that product.
The third configuration is a typical installation for
electronic boost controllers.
You should consult your boost controller’s instruction
manual for specific information on how each of the ports
of the solenoid valve should be connected.
This product is intended for racing use only, and it is the owner’s responsibility to be aware of the legalities of
fitting this product in his or her state/territory regarding noise, emissions and vehicle modifications.
This product may not work if installed correctly, and as such GFB makes no warranty against engine failure
when using this device.
GFB products are engineered for best performance, however incorrect use or modification of factory systems
may cause damage to or reduce the longevity of the engine/drive train components.
Warranty is for the period of one year from the date of purchase and is limited only to the repair or replacement
of GFB products provided they are used as intended and in accordance with all appropriate warnings and
limitations. No other warranty is expressed or implied.