J.P. Instruments EDM 730 Instrument Installation Manual - Manual

FAA APPROVED INSTALLATION MANUAL FOR THE EGT-701 Report 103
INSTALLING THE EGT-701 SCANNER®
1/20/09 Rev-E
THE OWNER OF THIS EDM-700/800/730/830
MUST KEEP THIS MANUAL
TABLE OF CONTENTS
Page
1)
INSTALLING THE INDICATOR 3
2) EXHAUST GAS TEMPERATURE PROBE 3
3) TURBINE INLET TEMPERATURE PROBE 3
4) CYLINDER HEAD TEMPERATURE PROBE 4
5) SPARK PLUG GASKET CHT PROBE 4
6) INDUCTION AIR TEMPERATURE PROBE 4
7) OIL TEMPERATURE PROBE 5
8) OIL PRESSURE TRANSDUCER 7
9) OUTSIDE AIR TEMPERATURE PROBE 7
10) FUEL FLOW OPTION 8
11) WIRING 9
12) EGT AND CHT PROBE WIRING 9
13) ROUTING THE WIRING HARNESS 11
14) MANIFOLD PRESSURE INSTALLATION & CALIBRATION 12
15) RPM SENSOR INSTALLATION 13
16) OPERATING INSTRUCTIONS 14
17) INDICATOR INSTALLATION & RECORD 16
18) ENGINE OPERATION 16
19) LIMITATIONS & OPERATION 16
20) COMPONENT PARTS LIST FOR EGT PROBE 17
21) COMPONENT PARTS LIST FOR CHT PROBE 17
22) COMPONENT PARTS LIST FOR OIL PROBE 17
23) COMPONENT PARTS LIST FOR OAT PROBE 17
24) COMPONENT PARTS LIST FOR MANIFOLD PRESSURE 17
25) COMPONENT PARTS LIST FOR RPM 17
26) COMPONENT PARTS LIST FOR SINGLE ENGINE EGT/CHT 17
27) WEIGHT AND BALANCE DATA 17
28) CHANGING PROGRAMMED LIMITS 18
29) TROUBLE-SHOOTING 20
FIG-1 INSTRUMENT BEZEL TEMPLATE 22
FIG-2 EGT/CHT/TIT PROBE PLACEMENT 23
FIG-3 EGT PROBE INSTALLATION 24
FIG-6 EGT/CHT PICTORIAL LAYOUT 25
FIG-7 WIRING DIAGRAM DRAWING 300701 26
FIG-9 DRAWING 700744 FUEL FLOW WIRING 27
INSTRUCTIONS FOR CONTINUED AIRWORTHINESS (ICA) 28
J.P.INSTRUMENTS Inc.
PO BOX 7033
HUNTINGTON BEACH CA 92646
FAA APPROVED 10-28-09
Last printed 05/16/13