J.P. Instruments EDM 960 Twin ICA Instructions User Manual
Page 6
EDM-960 Instructions for Continued
Airworthiness
Rev A
Date 4-8-2014 Page 6 of 6
11.0 Servicing
Servicing is “on condition” only. There are no field adjustments or calibration
requirements for the EDM-960 system after it has been properly installed, checked off
and signed-off by the respective authority. All servicing of the EDM-960 system and
accessories must be accomplished by J.P.Instruments Inc. (JPI). Probes,
transducers, sensors and the display unit are limited to removal and replacement with JPI
manufactured new or JPI remanufactured components. Location and access to the
components are described in the EDM-960 Installation Instructions (Report 909).
For servicing information contact J.P.Instruments Inc. at (714) 557-3805 or
.
12.0 Removal
Guidance on removal of the EDM-960 system and/or accessories is provided in the EDM-
960 Installation Instructions (Report 909). Removal must be performed in accordance
with applicable airworthiness standards.
13.0 Installation and Replacements
Installation of the EDM-960 and/or accessories must be performed in accordance with
the EDM-960 Installation Instructions (Report 909) and in accordance with applicable
airworthiness standards.
14.0 Troubleshooting
Troubleshooting the EDM-960 system and accessories, including probes, transducers and
sensors, must be performed in accordance with the Troubleshooting Section found in
the EDM-960 Installation Instructions (REPORT 909) section 39. Troubleshooting is
limited to identification of a defective component. A component’s internal workings should
only be repaired by J.P.Instruments Inc.
15.0 Special Instructions
There are no special instructions required for the EDM-960
System.
16.0 Special Inspection Requirements
There are no special inspection requirements for the EDM-960 System.
17.0 Special Tools
There are no special tools required for working on the EDM-960 System.
18.0 Revisions
These Instructions for Continued Airworthiness have been reviewed and accepted by
the FAA. In the event that a revision is required the revision will be submitted to the
FAA for review and acceptance. Before performing any procedures contained in the
manual the user should verify they have the latest revision by Checking the web site at
www.JPInstruments.com
for the latest revision of this manual. Owners of record will
also be notified by mail or e-mail of a revision update. The revised Instructions for
Continued Airworthiness must become a part of the aircraft records and a logbook entry
made noting the revision