AEM 30-2310 Inline Wideband UEGO Controller - Manual

Part Number 30-2310
INLINE WIDEBAND UEGO CONTROLLER
Figure 1. Wiring Schematic
Inline Wideband UEGO Controller Parts
1 x 30-2310 Inline Wideband UEGO Module
1 x 30-2001 UEGO Sensor
1 x 35-8535 Install Kit (UEGO Bung and 6 Butt Connectors)
1 x 10-2310 Installation Instructions
2 x Zip Tie
INSTALLATION
1. Disconnect the negative battery cable.
2. Find a suitable in-cab or under hood mounting location for the Inline UEGO
controller, away from any direct heat or water sources and shielded from the
elements. Secure the controller using the supplied zip ties as shown in Figure 3.
3. Connect the flying lead wires as shown in Figure 1.
4. Mount the UEGO sensor as shown in figure 2.
5. Plug the UEGO sensor connector on the UEGO controller into the mating
connector on the UEGO sensor.
AEM Performance Electronics
2205 126 th Street Unit A, Hawthorne, CA. 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
http://www.aemelectronics.com
Instruction Part Number: 10-2310 Rev 02
© 2011 AEM Performance Electronics