Class1 Electrical System Manager - Manual (Page 4)

4
System Configuration
The Electrical System Manager is configured by the use of five jumpers
labeled J1 through J5.
J1 and J5 control battery monitoring (MAIN or MAIN and ISOLATED.)
J2 controls the load reset method (MANUAL or AUTOMATIC.)
J3 controls Load Sequencing (OFF or ON.)
J4 controls when Terminal bar #15 is active (Low Voltage or High Voltage.)
The System Manager cover must be removed to change its operating mode.
J1 through J4 are located at the lower right edge of the circuit board, J5 is
located next to TB #10.
J5
TB#1
TB#9
TB#5
TB#13
TB#3
TB#11
TB#7
TB#15
TB#2
TB#10
TB#6
TB#14
TB#4
TB#12
TB#8
A B
MODE CONFIGURATION
Figure1
JMP DESCRIPTION
J1
POSITION POSITION POSITION POSITION
A B C D
BATTERIES MAIN
MAIN/
ISOLATED
J2
J3
J4
J5
RESET
SEQUENCE
TERMINAL #15
FUNCTION
MANUAL AUTO
OFF
ON
JUMPERS MAIN MAIN/
ISOLATED
FAST IDLE
CONTROL
OVER-VOLT
LIGHT