Class1 114356 - ITL 4LT with 1-wire and CAN COM 113739 114378 - Manual (Page 18)

FORM-ENG-0018 REV A 05-27-03
PAGE 17 of 22 S U I T A B L E F O R E X T E R N A L D I S T R I B U T I O N
OPERATION MANUAL
DATE 10/23/2007
PRODUCT GROUP ITL P/N 12V: 113739 ; 24V: 114378 REV 1.20
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : 352-629-2902 or 1-800-520-3473 PRODUCT 4 LIGHT INTELLI-TANK DISPLAY WITH 1-wire and CAN BY AMS
DATASHEET P/N:114356 - UNCONTROLLED IN PRINTED FORMAT - P RINTED : 10/24/07
7.5.5. CAN method, pump sensor module and 1 remote
System configured with CAN communication method. This example shows one remote display (using pump
sensor module address) following the indications of the Class 1 Pump Sensor Module.
7.5.6. Terminating resistor requirement (CAN communication)
A terminating resistor (120 Ohm) is required on both ends of the CAN bus for proper operation. Only two
terminating resistors are allowed on a CAN bus.
Terminating resistor p/n DT06-3S-P006
CAN “Y” connector p/n DT04-3P-P007