JB Conversions 16-1200 HD Standard Length SYE Kit for the NP231 - Manual (Page 8)

8
12) Loop the chain around the main sprocket and front output shaft
then lower the front output shaft through the bearing until it seats
firmly (Fig.13).
FIG: 13
13) Position the pump and pickup tube assembly into the rear case
half as shown (Fig.14). Install the rear case (with pump in place) onto
the front case half. Bolt the halves together using the original 10mm
bolts. When tightening the bolts, use a star pattern working from the
center out toward each side (Fig.15).
FIG: 14 FIG: 15