Apple Wireless Keyboard and Mouse - Manual (Page 3)

3
2
Congratulations on selecting the Apple Wireless
Keyboard and Mouse as your input devices. The
information in this booklet supplements the setup
instructions in the manual that came with your computer.
Setting Up Your Mac Using the Wireless Keyboard and Mouse
Follow the steps below to install batteries in the keyboard and mouse, set up your
computer, and use the Setup Assistant to set up your keyboard and mouse with
your computer.
Step 1: Install the Batteries
Your Apple Wireless Mouse comes with two nonrechargeable AA lithium batteries.
To install batteries in the mouse:
1 Turn the mouse over and remove the bottom cover.
2 Slide the batteries into the battery bay as shown in the illustration below.
3 Replace the bottom cover and leave the mouse turned off until you are ready to start
up your computer.
Slide this switch up to cover the
LED. This turns the mouse off.
To open the mouse, push this latch
downward slightly. This releases the
bottom cover.
Insert two AA batteries in the mouse. The positive ( + )
terminals on both batteries should be oriented
toward the LED.
LL2382.book Page 3 Friday, April 30, 2004 4:25 PM