Apple Cinema Tools 4 - Manual (Page 76)

• Daily Roll: The value entered in the Daily Roll field
• Ink Number: The value entered in the Ink field
Finding and Opening Database Records
You typically open database records in the Detail View window by selecting the record
in the List View window. The set of records displayed in the List View window is often
referred to as the found set, because you use the Find command to specify which records
are listed there.
Note: You can select only one record at a time.
To select a database record in the List View window
Do one of the following:
µ
Click any displayed record.
µ
Double-click a record to have its clip open in the Clip window.
µ
Use the keyboard’s Up Arrow key to select the record before the currently selected one.
µ
Use the keyboard’s Down Arrow key to select the record after the currently selected one.
µ
Use the keyboard’s Page Up key to jump up one page of records in the list.
µ
Use the keyboard’s Page Down key to jump down one page of records in the list.
Once you have selected a record, it stays selected as you change the display mode.
Important: You cannot change the settings in any of the records in the List View window.
Use the Detail View window to make changes.
To display specific records in the List View window
µ
Use the Find dialog.
See the instructions for using the Find command (below) for details.
To navigate through records within the Detail View window
µ
Click the Previous Record and Next Record buttons.
Previous Record and
Next Record buttons
76 Chapter 5 Working with Databases