Apple Ethernet CS Thin Coax Card - Manual (Page 9)

5
Installing EtherTalk software
To install the correct version of EtherTalk software
you need to use the Installer program on the
Network
Software Installer disk, version 1.4.2 or later, included
with your card.
For safety, make sure that the Installer disk is locked
before you use it. To lock a disk, slide the tab on the
back side so that the square hole is open.
Keep the Installer disk after installation in case you need
to reinstall EtherTalk software some time in the future.
To install EtherTalk software:
1. Insert the Network Software Installer disk
in your Macintosh and double-click the
disk’s icon to open it.
The Apple Ethernet CS Thin Coax Card requires
the versions of software supplied on the
Network
Software Installer disk, version 1.4.2 or later.
Open the disk to
find the Installer.