Apple AppleWorks 5 : Mac OS - Manual (Page 14)

1-10 AppleWorks 5 Installation Manual
Steps for installing AppleWorks 5 on a server
These instructions tell you how to install AppleWorks 5 on a network server
so multiple users can run one copy of the application. If you are not the
network administrator for the server, you should get the administrator’s
approval before installing AppleWorks.
1. Make sure that no one else is using the server.
AppleWorks 5 Installer requires that you restart the server after you have
installed AppleWorks.
2. Insert the CD-ROM disc, or the floppy disk labeled Disk 1 , into the appropriate
drive on the server.
3. Follow the instructions for “Doing an easy installation” on page 1-3 or for
“Doing a custom installation” on page 1-4.
4. Open the server’s System Folder and hold down the Option key as you drag the
Claris folder into the AppleWorks 5 folder on the server.
Holding down the Option key as you drag the folder copies (rather than
moves) the Claris folder.
5. Locate the AppleWorks folder, either in the System Folder or in the Application
Support folder (in the System Folder), and copy it to the AppleWorks 5 folder.
Users can now run AppleWorks 5 over the network. Be sure to advise them
of the limitations described in the previous section, “Limitations to sharing
AppleWorks 5.”